12/10/14-12/11/14

12/12/14

Had a good deal of laser cut parts made and assembled the front of the body.

12/11/14
Had the rest of the parts cut, tomorrow we will need to get our shaft couplings machined and then we will be ready for the expo.

Code:
I went home and updated the code, We were using an old library for the motor shield that was causing problems, I downloaded the new library and fixed the code. I also created a low power variant of the code, which runs a motor as a slower RPM.Allowing better demonstration of the direction the motors are spinning, plus it allows us to run off of power from the computer as opposed to the battery which is estimated to only last 1.5 hours.